| Drivability Development Engineer at Remote, Remote, USA |
| Email: [email protected] |
|
http://bit.ly/4ey8w48 https://jobs.nvoids.com/job_details.jsp?id=1062024&uid= From: roshini, s3 infinity [email protected] Reply to: [email protected] Calibration - Drivability Development Engineer Auburn Hills, MI Carrying out and analysis of tests intended for the calibration or validation of the Drivability and Engine-Gearbox Intersystem functions (characterization of the powertrain, idle speed PIV, anti-lock, PIV IS, not exhaustive) Engaging in development missions (hot; cold; temperate; altitude)Preparation and dissemination of reports Acquisition data filing Store the analysis results into a database Analysis of the issues encountered during the development process Development of precautionary, sustainable solutions, update of the repositories and carry over policy. Specification and coding of solutions for automatic processing of validation tests or from the data lake. Idle speed calibration (rpm, regulation) Calibration of component protection strategies BVM/BVMP/BVA take-off and brio (smoke mapping, anti-droop, idle robustness) System Validation Engine side anti-stall pre-calibration Calibration of the close control Basic PWT adaptation calibration Calibration of the component protection functions System calibration Functional and dysfunctional validation PWT functional integration Follow-up of functional and inter-system validation tests and follow-up of supplier development activities Calibration of BVA gear changes: stable foot, throttle release, pedal depression with different *Lock-up states in Drive and CMI Calibration of torque blending functions Calibration of commitments under all vehicle operating conditions Calibration of gearbox self-adaptive devices Torque bypass calibration. Anti-overspeed calibration. Calibration of temperature patches, drag reduction, turbine torque recovery function, calibration safety. Calibration and validation of component protection functions Validation of engine and PWT behavior (quality of torque exchange, compliance with gearbox requirements, compliance with rpm instructions, etc.) during gear shifts Validation of PWT behavior in Lock-up management phases Validation of intra-PWT and PWT-vehicle exchanges (flow, quality) Engine software validation at each project phase System calibration (converter status, ratio, gearbox learning, etc.) Functional and dysfunctional validation of the gearbox software Calibration and validation of PWT degraded modes Calibration and anti-lock validationMastering the calibration of learning (transmissibility, kisspoint, grid, synchro point, clutch actuator) Mastering the thermal models (clutch, hydraulics) Thermal models calibrations (clutch, hydraulic oil) Take-off Calibration Clutch opening/closing calibration without gearshift Clutch opening/closing calibration with gearshift Calibration of torque blending functions Calibration of hypershift mode gear shifts Fine-tune calibration and anti-lock validation Calibration of automatic switch thresholdsWarmup calibrations and verifications Inter-system optimization Engine Torque accuracy verification Fine-tune calibration and anti-lock validation Drivability objective evaluation ADAS interactions Keywords: sthree Michigan http://bit.ly/4ey8w48 https://jobs.nvoids.com/job_details.jsp?id=1062024&uid= |
| [email protected] View All |
| 12:06 AM 30-Jan-24 |